Micronics PCI/ISA System Board D6-IN Bedienungsanleitung PDF herunterladen (Seite 31)

4-8

Micronics M6Pi System Board Manual

Parallel Port

The parallel port may be set for LPT1 (default), LPT2, or may be disabled.

Parallel Port Mode

The parallel port may be set for output mode (AT) (default), bidirectional

mode (PS/2), Enhanced Parallel Port (EPP), Extended Capabilities Port (ECP),

or Disabled.

Diskette Controller

The floppy disk controller may be set for Enabled or Disabled.

IDE Controller

The IDE controller may be set for Primary Only (up to two hard disks),

Primary and Secondary (up to four hard disks), or it may be disabled.

Boot Sequence

This category selects the order the system searches for a boot disk and may be

set for A: then C:, C: then A:, or C: only.

Plug & Play O/S

This category, when set to Yes, allows the system to work with a Plug & Play

operating system such as Windows 95. The default setting is No.

Reset Configuration Data

Select Yes to clear the PCI Plug & Play configuration data. The default setting

is No.

Large Disk Access Mode

If you are using a DOS operating system (MS-DOS, DR-DOS, or PC-DOS),

set this category to DOS (default). If you are using anything else, set it to

OTHER.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 50 51

Keine Kommentare

Micronics PCI/ISA System Board D6-IN Bedienungsanleitung Seite 31